in this video we'll review the user
settings menu user settings can be
accessed by pressing the top two buttons
simultaneously once in user settings
you'll see temp set points active faults
fault history and depending on
configuration scheduling fan speed and
outdoor air setting it is important to
note that adjusting scheduling fan speed
and outdoor air setting can alter unit
activation capacity and performance
these should only be adjusted by a
qualified technician with permission
from tech support to prevent unintended
operation to change space temperature
select temp set points and space set
points to display the current Heating
and Cooling set points use the up or
down buttons to highlight either set
point and press enter to edit that value
now that the current highlighted value
is selected you can use the up or down
buttons to modify the set point once the
desired changes have been made you
should press the enter again which will
then highlight the entire line
signifying the change has been stored
while increasing a heating set point
don't be alarmed if the cooling set
point changes as well the same is true
for decreasing a cooling set point our
unit will maintain a gap or deadband
between the two climate control set
points to keep the unit from cycling
back and forth frequently between
heating and cooling it is advised that
intake set points discharge limits and
humidity control are not modified as
this could affect unit activation cause
unintended discharge temperatures or
result in poor space humidity any
changes to these set points should be
approved by Tech Support to ensure theit
unit meets the sequence of operation and
ideal building conditions are
maintained also in user settings are
active faults and fault history if any
faults are present they will be
displayed in active faults if you have a
current active fault please reach out to
captiv a so we can help get it resolved
promptly fault history will store a log
of all past faults with a date and time
stamp per fault don't be alarmed if
there are faults present as our units
are tested extensively in our
manufacturing facilities and during the
system design verification process
default history can be cleared in our
service menu which will be covered in a
later video the units occupied and
unoccupied operating set points can also
be modified in the scheduling section in
the user settings simply enter
scheduling then scheduling times to view
the current start and end for a time of
occupancy up to three shifts a b or c
can be configured per day to apply
varying set points as different heat
loads or heat demand is necessary for a
variance in application once you
configure your desired schedule can be
applied to the remaining days of
occupany using the copy schedule
function here you can copy a schedule
from one day to the next or from one day
to all weekdays or all days as always
it's important to remember that your
unit schedule was configured from the
factory for your application any change
to the schedule should be approved by
text support prior to being made