YouTube Video - Paragon HVAC - HMI Scheduling and Temperature Overrides

YouTube Video - Paragon HVAC - HMI Scheduling and Temperature Overrides

Video Transcript
0:00
now that you're familiar with the
0:01
display of the HMI let's dig a little
0:03
deeper into the function of it if on or
0:06
off is not present on your HMI or if an
0:08
override button is present this
0:09
typically indicates that scheduling is
0:11
enabled and the unit can enter an
0:13
occupied or unoccupied State depending
0:15
on the scheduling settings and occupancy
0:17
timing pressing the override button also
0:19
manually forces the unit into an
0:21
opposing occupancy State temporarily for
0:23
60 Minutes during the occupied times the
0:26
unit can accurately Target optimal space
0:28
conditions regardless of varying space
0:30
Bas heat loads while unoccupied the
0:33
temperature set points can be set more
0:34
conservatively to sacrifice space
0:36
temperatures some while shifting the
0:38
focus to Energy savings we suggest
0:40
unoccupied setbacks of no more than 2 to
0:43
3° if on or off is displayed on your HMI
0:46
the unit does not have scheduling
0:47
configured and will need to be manually
0:49
enabled or disabled by pressing on or
0:51
off after the on button has been pressed
0:54
off will now be displayed indicating the
0:55
unit has been enabled and may now be
0:57
shut down by pressing off at any time
1:00
the climate control State idle should
1:02
change to blower and eventually to heat
1:04
or cool depending on current set points
1:06
and space conditions it is important to
1:09
remember that pressing the off button
1:11
will shut the unit down abruptly which
1:12
can be harmful to various mechanical
1:14
components off should only be pressed
1:17
when the unit is in an idle State at the
1:19
end of a shift or in the event of an
1:21
emergency pressing the temp Plus or temp
1:23
minus button will override the current
1:25
temperature set points and move both the
1:27
heating and cooling set points
1:29
respectively for a short period of time
1:32
the default temperature override maximum
1:33
is plus or minus 5° for 60 Minutes the
1:37
temperature offsets and override timer
1:39
can both be modified in the factory
1:40
configuration by tech support if
1:43
necessary it is important to note that
1:45
temperature overrides can be restricted
1:46
by discharge limits which are also
1:48
covered later so don't be alarmed if you
1:51
can temporarily decrease the temperature
1:53
set points by 5° but only increase them
1:55
by 2° contact tech support if a
1:58
temperature override is required ired
2:00
frequently this indicates the heating
2:02
and cooling set points need to be
2:04
fine-tuned further for the application
and we'd be happy to help with this